Bicycles

Simplified electronic shifting system bodes well for cyclists' wallets

Simplified electronic shifting system bodes well for cyclists' wallets
The eXCD rear derailleur – the system doesn't incorporate a front derailleur
The eXCD rear derailleur – the system doesn't incorporate a front derailleur
View 2 Images
The eXCD rear derailleur – the system doesn't incorporate a front derailleur
1/2
The eXCD rear derailleur – the system doesn't incorporate a front derailleur
The eXCD shifter
2/2
The eXCD shifter

Like many emerging technologies, electronic gear-shifting systems for bikes are currently at the point where they exist, but they're still quite expensive. For examples, take a look at the offerings from Shimano, Campagnolo and SRAM. That could be about to change, though, with the upcoming introduction of MicroSHIFT's simplified eXCD system for mountain bikes.

Right off the bat, it should be noted that exact pricing for eXCD has yet to be determined. That being said, there's definitely reason to believe that it may be significantly less costly than its competitors.

For starters, instead of utilizing a proprietary battery pack, it's powered by two rechargeable AA lithium batteries. These are located in the handlebar-mounted push-button electronic shifter/controller, and should be good for over six hours of continuous shifting per charge – MicroSHIFT also quotes battery life figures of 6,000 individual shifts, or over 1,000 km (621 miles) of average riding.

The eXCD shifter
The eXCD shifter

The choice of standard 14500-type AA's means that buyers won't be paying for a purpose-built battery pack. Additionally, should users find themselves with dead batteries right before a ride, they can simply buy a new pair at a corner store instead of waiting to recharge. To keep that from being necessary, though, LEDs on the shifter keep users apprised of the current charge level.

The other reason that eXCD may be inexpensive is the fact that unlike most other electronic systems, it is not wireless. Instead of sending shift commands by radio signals, it uses a connection cable that runs directly from the shifter to the capacitor-equipped rear derailleur – the system doesn't include a front derailleur. This hard-wired setup will result in some cable-clutter, but it once again minimizes the amount of electronics that buyers will have to pay for.

Not much else is currently available in the way of specs, apart from the fact that eXCD offers the same gear capacity as a single 35t chainring combined with an 11-42t cassette (a 3.8 gear ratio), along with a one-way clutch on the derailleur to aid in chain retention, and the ability to fine-tune gear settings via the shifter.

A MicroSHIFT rep tells us that the system should be available sometime next year, and that the company will "focus on the mid price level to satisfy the demand from general riders."

Source: MicroSHIFT via BikeRadar

5 comments
5 comments
MikeF
"...unlike most other electronic systems, it is not wireless". Er, most other electronic systems are also not wireless, the only current exception is SRAM.
LakeeshaGobeatcha
So where is the advantage here? I give up my twist or lever shifter for a pushbutton shifter and get 7 to 9 gears instead of my current 21 to 27? And I pay a premium for it? What are these people thinking?
ThomasSwaggerty
"Additionally, should users find themselves with dead batteries right before a ride, they can simply buy a new pair at a corner store instead of waiting to recharge"
The AA batteries are not the same as the ones at a 7-11, they are 3.6 volt rechargeable lithium cells. Putting some duracells in this unit would do nothing at all, the lithium cells that you can get in stores are 1.7 volt primary (nonrechargeable) cells and can't be used here.
"The other reason that eXCD may be inexpensive is the fact that unlike most other electronic systems, it is not wireless."
As the other commenter pointed out Shimano and Campagnolo's electronic groupsets are wired, SRAM's wireless etap is the only wireless groupset released and that was in the last 6 months.
Marc Stinebaugh
And it isn't being powered/charged by the bike, why?
habakak
@SherlockMcGyver.....dude, you should be able to figure that one out. Or come up with a reason why not. Lemme give you a hint....cost (and complexity). Baby steps....
This sounds like a good development. And 1x drivetrains for mountain biking is possibly the best development in biking in the last 3 or 4 years. I also like the development of plus wheels, but 1x I think is the magic.
This takes it to another level, although I prefer the wireless setup (which hopefully MicroShift would deploy in a later iteration of this product).
Stretching cables is really not the biggest deal. After the initial stretch over the first few rides, not much changes. Bending derailleur hangers or the derailleur itself is much more of an issue when it comes to shifting trouble than stretching cables. Also harder to fix.
At this point I don't know if electronic shifting (specifically on the mtb) offers much, but I would like to try it to make up my mind. Internal gears and no-load shifting is what we really need (in the mtb world).